Crochet Candy Corn Keychain – Free Mini Halloween Pattern

Make a cheerful little Halloween accessory with this crochet candy corn keychain pattern. Its white tip, orange middle, and yellow base give it the familiar candy corn look, while a tiny embroidered smile adds a friendly finishing touch.

The small size makes it easy to attach to your keys, decorate a project bag, or add a handmade detail to an autumn gift. You only need small amounts of three yarn colors, a little stuffing, and a split key ring.

This pattern creates a softly rounded, tapered amigurumi charm. The body is crocheted in one piece from the white tip downward, with color changes for the orange and yellow sections. A separate crochet base closes the bottom, and a short reinforced loop connects the charm to the key ring.

Pattern note: This written pattern has not been physically tested. Stitch counts have been checked, but finished size and yarn quantities are estimates. The AI-generated images illustrate the intended appearance and stages; exact proportions and stitch structure may differ.

Project Overview

• Skill level: confident beginner.
• Terminology: US crochet terms.
• Estimated body height: 5–7 cm, depending on yarn and tension.
• Construction: one tapered body, separate base, and hanging loop.
• Main stitch: single crochet.
• Face: embroidered eyes and smile.
• Suggested yarn: fine or DK cotton.
• Suggested hook: 2.5–3 mm, adjusted to suit your yarn.

The finished shape is a rounded cone with a broad base. Gently flattening the stuffed body gives it a more triangular front view. For a smaller charm, use finer yarn and a smaller hook. Keep all three colors in the same yarn weight.

Materials and Tools

• White cotton yarn: approximately 3–5 g.
• Orange cotton yarn: approximately 5–8 g.
• Yellow cotton yarn: approximately 5–8 g.
• Black embroidery thread or fine black yarn.
• 2.5–3 mm crochet hook.
• Small amount of polyester stuffing.
• Metal split key ring, approximately 20–25 mm across.
• Yarn needle, embroidery needle, stitch marker, and scissors.
• Optional strong sewing thread to reinforce the loop.

Choose tightly spun cotton that produces clear stitches and holds its shape. Avoid changing yarn thickness between the colored sections. Use a hook small enough to create firm fabric. Stuffing should remain hidden when the piece is gently squeezed.

This keychain includes small metal parts and is intended as an accessory, not a baby toy.

Abbreviations

MR = magic ring; ch = chain; sc = single crochet; inc = 2 sc in one stitch; sl st = slip stitch; st/sts = stitch/stitches.

Numbers in parentheses show the total stitch count. For example, (sc 3, inc) × 3 (15) means repeat three single crochets followed by an increase three times, finishing with 15 stitches. No decreases are needed for the body. A separate base closes its widest opening.

Before You Start

Work the body in continuous rounds without joining. Mark the first stitch of each round and move the marker upward as you work. Count after every increase round: small errors can noticeably change a miniature project’s proportions.

The color order is white at the narrow top, orange through the middle, and yellow at the broad bottom. Leave the bottom accessible until the face and loop are attached, making it easier to secure thread ends inside.

How to Change Colors

On the last stitch before a color change, begin the single crochet with the current color. Pull up a loop, leaving two loops on the hook. Yarn over with the new color and pull through both loops. Continue with the new yarn.

Leave tails long enough to secure inside. Avoid bulky knots behind the face. Continuous rounds can create a step where colors meet. Position color changes at the back so the front looks cleaner.

Step 1: Crochet the White Tip

Using white yarn:

• Round 1: 6 sc into a MR. (6)
• Round 2: sc in every stitch. (6)
• Round 3: (sc 1, inc) × 3. (9)
• Round 4: sc in every stitch. (9)
• Round 5: (sc 2, inc) × 3. (12)

Change to orange on the final stitch of Round 5. Pull the magic ring closed securely. The tip should be gently rounded, with no gap. Later, attach the hanging loop through several stitches around this area rather than relying on the magic ring strand alone.

Step 2: Crochet the Orange Middle

Using orange yarn:

• Round 6: (sc 3, inc) × 3. (15)
• Round 7: sc around. (15)
• Round 8: (sc 4, inc) × 3. (18)
• Round 9: sc around. (18)
• Round 10: (sc 5, inc) × 3. (21)
• Round 11: sc around. (21)

Change to yellow on the final stitch of Round 11. The body gradually widens from the white tip. Maintain consistent tension at color changes so the orange section does not develop a tight band. Mark the front opposite the color-change seam. Do not stuff yet.

Step 3: Crochet the Yellow Base Section

Using yellow yarn:

• Round 12: (sc 6, inc) × 3. (24)
• Round 13: sc around. (24)
• Round 14: (sc 7, inc) × 3. (27)
• Rounds 15–16: sc around. (27)

Slip stitch into the next stitch and fasten off, leaving a tail to secure inside. The bottom stays open until the separate panel is attached. Inspect the taper: white should be narrowest, orange should widen gradually, and yellow should form the broad lower section. Count stitches if one side is uneven.

Step 4: Embroider the Face

Use black embroidery thread or fine yarn. Position the eyes around Rounds 8–9, approximately three stitches between their inner edges. Adjust spacing to suit the actual width.

• Bring the needle from inside the body to the chosen eye position.
• Make two or three small vertical stitches over the same area.
• Keep the thread relaxed enough to avoid puckering.
• Secure ends inside.

Embroider a curved smile below and between the eyes using two short diagonal stitches meeting at a lower center point. Keep it inside the orange band. Check the face from the front before securing it. Omit the face if you prefer a traditional candy corn accessory.

Step 5: Make and Attach the Hanging Loop

Using white yarn, leave a starting tail about 15 cm long. Row 1: ch 7. Row 2: starting in the second chain, sc in each chain (6). Fasten off with another long tail.

Fold the narrow strap with its ends meeting. Check that the ring can pass through the resulting loop. Make the strap longer if your ring is thick or your stitches are especially tight.

Sew both strap ends at the white tip through several body stitches on opposite sides of the top. Make several attachment passes with both tails. Support the loop with the crochet fabric, not only the magic ring strand. Secure ends inside. Reinforce with matching sewing thread if needed.

Open the split ring carefully and feed it through the loop as you would add a key. Avoid forcing it through individual body stitches.

Step 6: Crochet the Separate Bottom Panel

Using yellow yarn:

• Round 1: 6 sc into a MR. (6)
• Round 2: inc around. (12)
• Round 3: (sc 1, inc) × 6. (18)
• Round 4: (sc 2, inc) × 6. (24)
• Round 5: (sc 7, inc) × 3. (27)

Slip stitch into the next stitch and fasten off with a long sewing tail. The panel’s 27 stitches match the body opening. Check that it covers the bottom without heavy stretching. Slight cupping is acceptable for a softly rounded base.

Step 7: Stuff, Close, and Shape

Add small amounts of stuffing through the bottom. Guide a little filling toward the white tip using a blunt tool. Fill the orange and yellow sections gradually. Keep the charm supported but slightly soft: excess stuffing stretches the stitches and makes it too round.

Match the panel’s 27 stitches to the body’s 27 stitches. Whipstitch around the edge, passing through corresponding stitches. When three-quarters attached, check the stuffing and adjust, then finish the seam. Secure and bury the tail.

Gently flatten the front and back between your fingers and smooth the broad base. Give the loop a gentle pull while supporting the body. Reinforce it if the attachment shifts.

Finishing Checklist

• Colors follow white, orange, yellow from top to bottom.
• Magic ring and bottom seam have no gaps.
• Face and loop are secure.
• Stuffing is hidden.
• Yarn tails are woven in.
• Split ring is fully closed.

A neat finish matters on a small accessory, where loose ends and uneven seams are easy to notice.

Helpful Tips and Troubleshooting

My candy corn looks too round

Remove some stuffing before closing. Flatten the front and back gently. This pattern produces rounded amigurumi, not a flat triangular appliqué.

Stuffing shows through

Use a smaller hook or less filling. Close stitches work better than adding stuffing to hide gaps.

Color changes look uneven

Keep changes at the back, complete the preceding stitch with the new color, and avoid tightening tails excessively.

The face looks off-center

Mark the front and position eyes around it, rather than using the round’s beginning as the center.

Can I omit the ring?

Yes. Tie the loop to a gift ribbon, or omit both loop and hardware for a small autumn decoration.

Can I use leftover yarn?

Yes, if the colors have similar thickness and fiber behavior. Mixing weights can distort the taper.

More Crochet Accessories

For another seasonal charm, try our crochet witch hat keychain pattern. For a larger project, explore the Halloween trick-or-treat bag pattern.

Styling and Gift Ideas

Attach the charm to a project bag or suitable zipper hardware. For gifting, place it on a kraft card or tie it to an autumn present. Keep packaging understated so the three bright colors stand out. Make matching charms with different embroidered expressions.

Care Instructions

Spot-clean according to the yarn label. Avoid soaking the metal ring and dry the body completely before using it. Check the loop occasionally, particularly when carried with keys daily. Repair worn attachment stitches before they loosen further.

This crochet candy corn keychain adds a cheerful handmade touch to Halloween accessories with small amounts of yarn and simple assembly.