Flowers

Crochet Dahlia Pattern with Pointed Folded Petals

Crochet a burgundy dahlia with twelve pointed folded petals in two rings. Includes disk counts, cone folding and backing placement.

Save & share Pinterest ↗ Facebook ↗
Burgundy crochet dahlia with twelve pointed folded petals in two rings

This burgundy crochet dahlia uses twelve small disks folded into pointed cones and sewn in two rings. Six larger outer petals alternate with six smaller inner petals around a small coiled center. A flat green backing holds the bases while the points radiate outward.

Make six eighteen-stitch burgundy disks and six twelve-stitch disks. Fold each by overlapping its sides to create a pointed cone. Sew the large petals to six paired positions on a twenty-four-stitch backing, then add six smaller petals in the intervening paired positions and a short coiled chain center.

Project Overview

DetailInformation
TermsUS crochet
SkillConfident beginner with sewing
ConstructionMake six eighteen-stitch burgundy disks and six twelve-stitch disks. Fold each by overlapping its sides to create a pointed cone. Sew the large petals to six paired positions on a twenty-four-stitch backing, then add six smaller petals in the intervening paired positions and a short coiled chain center.
TestingArithmetic reviewed; physical sample not tested

Project views are generated illustrations of the intended construction. Sizes, yarn use and attachment performance remain unverified on a physical sample.

Materials

MaterialSuggested specification
CottonAbout 25–35 g burgundy and 5 g green fine cotton; estimate
Hook2.5 mm or suitable size for dense flexible fabric
ToolsNeedle, markers, pins and scissors
Burgundy green cotton hook needle pins and scissors

Size and Gauge

The intended bloom is about 7–9 cm across in fine cotton, but no physical sample has been measured. Its width depends on the cone overlap and petal spread. Keep one finished folded petal as a comparison for the remaining five in each size; equal final disk counts alone do not guarantee equal cone shapes.

Abbreviations and Working Notes

TermMeaning
chChain
scSingle crochet
sl stSlip stitch
inc2 sc in one stitch
decInvisible sc decrease over 2 stitches
MRMagic ring
dcDouble crochet

US terms. Work joined single crochet rounds, excluding the joining slip stitch and ch 1. All twelve petals use burgundy; there is no separate contrast flower center.

A cone here is a folded flat disk, not a stuffed tube or a mathematically closed cone. The disk sides overlap and are sewn only near their lower inward-facing base.

There are exactly six outer and six inner petals. No wire, stem, glue, leaves or stuffing is included.

Crochet Six Larger Petal Disks

Round / stageInstructionsCount / check
16 sc in MR; join6
2Inc around; join12
3(Sc, inc) × 6; join18

Make six disks, leaving a sewing tail on each. Keep the disks flat and compare the edges. A tight ring may be closed snugly, but do not pull the center so hard that the entire disk cups before folding.

Large burgundy eighteen stitch petal disk before folding

Crochet Six Smaller Petal Disks

Round / stageInstructionsCount / check
16 sc in MR; join6
2Inc around; join12
QuantityFinish with long tails6 smaller disks

These inner petals stop one round earlier. Keep the hook and cotton the same as for the outer ring; reducing hook size instead would change flexibility as well as diameter. Lay the two sets apart so the assembly does not alternate sizes accidentally.

Fold and Secure Each Point

Round / stageInstructionsCount / check
FoldOverlap left and right disk edges toward centerPoint outward, curved opening inward
BasePin the overlapping lower fabricLeave curved rim open
SeamMake small passes through overlapped layers near baseOne stable folded petal

Arrange a disk with one edge facing outward. Bring the two side edges over each other so the outermost fold forms a narrow pointed end. The open curved rim and overlapping attachment area sit toward the flower center. Do not sew the whole curved rim shut or stuff the pocket. Make the same overlap on all six disks of each size and compare the resulting points before sewing them to the backing.

Six large and six small burgundy folded cone petals with green backing

Make the Green Backing

Round / stageInstructionsCount / check
16 sc in MR; join6
2Inc around; join12
3(Sc, inc) × 6; join18
4(2 sc, inc) × 6; join24

Leave the backing flat. Mark twelve consecutive pairs around its rim: 1–2, 3–4 and so on through 23–24. These are spacing references for attaching bases, not extra crochet rounds. Keep the green face that you want visible at the back facing away from the petals.

Arrange Two Alternating Petal Rings

Round / stageInstructionsCount / check
Outer sixBases at rim pairs 1–2, 5–6, 9–10, 13–14, 17–18, 21–22Six larger petals
Inner sixBases near pairs 3–4, 7–8, 11–12, 15–16, 19–20, 23–24Six smaller petals
CenterBurgundy ch 13; sl st back 12; coil and stitchOne small spiral

Pin the outer six first, all points facing away from the backing center. Sew each overlapped petal base across both marked backing stitches and catch neighboring dense fabric for a broad join. Add the smaller ring slightly closer to the center, between the outer points. Its bases can overlap the sewn outer bases; keep the tips visible. Coil the narrow slip-stitch strip without stretching it and sew it over the remaining center joins.

Pinning two alternating rings of folded dahlia petals before center coil

Refine the Bloom

Round / stageInstructionsCount / check
CountSix large and six small points remain visible12 petals total
BackNo long yarn floats across backingEnds buried
ShapeAdjust each folded opening gentlyNo glue or stiffener

Remove every pin and inspect each folded seam before shaping. Spread the points by hand while supporting the backing; do not pull a petal by its tip. The intended flower is flexible and softly dimensional, not a rigid geometric ornament. Physical stability of the folds still needs a sample test.

Troubleshooting

ProblemLikely causeAdjustment
Petals look tubularEdges closed along entire rimKeep curved opening free
Uneven outer ringDifferent cone overlapsCompare all six before sewing
Green gaps visibleBases spread too far apartRepin with gentle overlap
Center bulkyCoil stretched or doubledUse one narrow strip

Care and Related Projects

Follow cotton care instructions and reshape damp without stretching points. Dry flat supported from beneath. Avoid crushing folded petals during storage.

For another useful construction reference, see this related crochet project. Its stitch counts and attachment positions belong to that project; keep the instructions for this design separate.

Back view of burgundy crochet dahlia with flat green backing

Frequently Asked Questions

How many petals are included?

Twelve: six larger outer petals and six smaller inner petals.

Are the petals stuffed?

No. They are flat disks folded and sewn near the base.

Is the center a bead?

No. It is a short burgundy slip-stitch chain coiled and sewn.

Can the backing be omitted?

The backing supplies the placement and attachment surface. Omitting it changes the assembly.

Compact Pattern Card

StageKey instruction
Crochet Six Larger Petal Disks(Sc, inc) × 6; join
Crochet Six Smaller Petal DisksFinish with long tails
Fold and Secure Each PointMake small passes through overlapped layers near base
Make the Green Backing(2 sc, inc) × 6; join
Arrange Two Alternating Petal RingsBurgundy ch 13; sl st back 12; coil and stitch
Refine the BloomAdjust each folded opening gently